Display Images

Materials

  • AMB82-mini x 1

  • Waveshare E-Paper [2.9inch E-Paper HAT (D)/ 2.9inch E-Paper V2/ 2.9inch e-Paper Module (B)/ 4.2inch e-Paper Module/ 7.5-inch E-Ink display HAT] x1

Example

Introduction

In this example, Ameba Pro2 board will be used to connect to a Waveshare e-Paper module (2.9inch/ 4.2inch/ 7.5inch) to display images. The display uses the flexible substrate as base plate, with an interface and a reference system design. You may refer to the official datasheet to know more information about these modules.

Procedure

AMB82-Mini wiring diagram:

2.9inch HAT (D) e-Paper Module

image01

2.9inch E-Paper V2 e-Paper Module/ 2.9inch e-Paper Module (B)

image02

4.2inch e-Paper Module

image03

7.5-inch e-Paper Module

Do note that Display Config should be set to B and Interface Config should be set to 0.

image04

Firstly, prepare a picture/photo and resize the image based on the e-Paper display that you are using. You can look for a photo resizing tool online, for example, the Online Image Resizer. Simply follow the instructions on the website to resize the picture and download the resized image in JPEG format.

2.9” e-Paper module: 296x128 pixels

4.2” e-Paper module: 400x300 pixels

7.5” e-Paper module: 800x480 pixels

Secondly, use Image2LCD tool to convert the resized JPEG image into hexadecimal codes. You can visit this YouTube link to learn more about how to use the Image2LCD tool.

Next, download the Eink zip library, AmebaEink.zip, at https://github.com/ambiot/ambpro2_arduino/tree/dev/Arduino_zip_libraries Then install the AmebaEink.zip by navigating to “Sketch” -> “Include Library” -> “Add .ZIP Library…”.

Eink examples are categorised based on the size and modules of the e-Paper display.

image05

Open one of the “EinkDisplayImages” examples. For example, “File” → “Examples” → “AmebaEink” → “EPD_2in9v2”-> “EinkDisplayImages”:

image06

You may choose any GPIO pins for Busy, Reset and DC pin. You can refer to for AMB82-Mini’s pinmap.

image07

Upload the code to the board and press the reset button after uploading is done. Wait for around 1-2 seconds for the e-Paper module to refresh its screen. Images will start to loop on the e-Paper display, each image will be displaying for 4 seconds.

image08

image09

The 2.9-inch e-Paper Module (B) supports three colours—red, black, and white. You may refer to the example for 2.9-inch e-Paper Module (B) to learn how to display red images by navigating to “File” → “Examples” → “AmebaEink” → “EPD_2in9b”-> “EinkDisplayImages”.

Red image displaying on 2.9-inch Module (B) e-Paper display is shown below.

image10